Skip to content

Quick Tips To Check Stirrup Length

Appropriate stirrup length is critical for all levels and disciplines of riders. It is important for safety, for rider balance and for the effectiveness of the rider in developing correct riding skills. Time and time again in clinics, I see riders with stirrups mal-adjusted. Over the years, I’ve developed a keen eye for knowing when the stirrup length is appropriate and when it needs adjusting, but I can tell you that it is not always easy and there is a lot of variance.

For starters, you need to know the appropriate stirrup length for the style of riding, or discipline, such as English/Western, Dressage, Reining, Saddle seat, Cutting, Jumping, Roping, etc. For instance, dressage and saddle seat are generally the longest lengths, while jumping is the shortest. Some western disciplines such as roping, cutting or barrel racing are short, while other western disciplines need longer lengths.

Fortunately, there are some commonalities between all disciplines of riding that will help you determine if the length is correct for the rider. There is a wide range of acceptable lengths, but too long or too short can cause major problems in your riding. More often than not, I see riders (particularly western) riding with their stirrups too long, making their lower leg dysfunctional and putting them out of position. Occasionally riders have their stirrups too short (mostly hunt seat riders), but since this tends to be less comfortable, it is not as common.

For balance, the rider must be able to sit comfortably in the balanced position of ear-shoulder-hip-heel alignment. If the stirrup is too long, no matter what discipline, the rider will have to reach with her toes for the stirrup and this will cause her to ride in the heel-up position, with the leg too far forward. No matter what the discipline, when the heels are up and the leg is not aligned, the rider is not balanced, anchored on the horse or able to use her leg aid to communicate effectively with the horse.

To gauge proper stirrup length, I check the stirrup length visually from both in front of the rider/horse (with her feet out of the stirrups and saddle square) and from the side, perpendicular to the horse.

From the front, check that the stirrup length is equal on both sides. Uneven stirrups are amazingly common—I find it in almost every clinic I do. Make sure to have the rider square his saddle and then take his feet out of the stirrups, to determine if the rider’s stirrup length is level or not.

My two favorite ways to judge by eyesight if the rider’s stirrup length is correct, are to 1) look at the angle of the rider’s leg between the thigh and lower leg, and 2) by comparing the angle of the rider’s thigh and the horse’s shoulder.

1. Looking from the side, the angle of the rider’s leg, between the thigh and lower leg, should be an equal angle. If the angle of the leg is not equal, it usually means that the rider’s stirrup is too long and the lower leg is hanging straight down while the angle of the thigh is more or less at 45 degrees, making the angle unequal.

2. Looking from the side, the angle of the rider’s thigh should be more or less parallel with the angle of the horse’s shoulder (the line from mid-withers to point of shoulder). This handy eyeball check is helpful for insuring the best ride when the rider is mounted on a choppy, straight-shouldered  horse. In general, the steeper the angle of the horse’s shoulder, the rougher the horse’s gait. When the horse is rough gaited, the rider needs a longer-than-normal stirrup length to help anchor the rider onto the horse’s back.

Conversely, if the angle of the rider’s thigh is high compared to the horse’s shoulder, it is easier for the rider to ride in a more forward position and get up off the horse’s back. This might be important for riding jumpers, racehorses or for roping.

There are a few measurements that I know of that you can use to gauge appropriate stirrup length. One is to measure the stirrup length compared to the rider’s arm, from the ground. To do this, the rider puts his fingertips on the stirrup bar and pulls the stirrup into his armpit. This gives you a ballpark figure on which to judge proper length; the length of the stirrup should be about the length of the rider’s arm.

The stirrup length may need to be fudged in length one way or the other depending on the horse’s build. Awkward scenarios like a big person on a little horse or a little person on a big horse or a narrow person on a wide horse may have a bearing on which way you fudge the stirrup length.

Another way to measure stirrup length, once the rider is up on the horse, is to have the rider hang his leg straight down and see where the bottom of the stirrup is in relation to the anklebone. If the stirrup hits right at the ankle bone, it is a good length for most riders. Once again, this will provide you with a ballpark figure, but fine-tuning of the length may still be in order.

Personally, I am not a fan of the third technique for measuring the rider’s stirrup length, although many instructors are. This measurement is taken by having the rider mount, then stand in his stirrups to see if you can fit your fist between the rider’s seat and the seat of the saddle.

The problem with this technique is that unless and until the rider can properly stand in the stirrups, this measurement is useless. If the rider rises in the stirrups by pushing up off the stirrup, straightening the knee and lifting the heel (as most novice riders do), there will always be plenty of room between the crotch and saddle. Only when the rider uses correct rising technique and rolls onto his thighs while the leg and heel lengthens, will this measurement be accurate.

As you can see, there are many methods to judge the proper stirrup length and there are many variables that affect the proper length, such as the rider’s build, the size and gait of the horse, the saddle and the activity the rider is participating in.

Since there is a wide range of acceptable length, there can be small adjustments up and down considering your activity. For instance, when jumping you will generally raise your stirrups one or two holes from where you would ride doing flat work only. I raise my stirrups when I am working cattle, but drop them down a hole for trial riding. In general, I prefer a little shorter stirrup than average, but I make sure the length I ride promotes good position. 

Having the right stirrup length is a critical ingredient to a rider’s success. Being able to judge if the stirrup length is correct in other riders can be a challenge and judging your own stirrup length can be even more challenging. If you have been riding for some time with an inappropriate length, it may take some getting used to when you adjust them—but if it makes you a better rider, then it is worth it!

Enjoy the ride,
Julie
Please visit Goodnight’s sites for more information and training tips:
http://www.juliegoodnight.com
http://www.horsemaster.tv
You Might Also Like...

7 Comments

  1. Its always a huge struggle for me to get a good saddle.. Im 4’11 and my horse is (16.8) I usually just ride bare back it is so much more convenient and a faster process! What are good brand saddles jumping, and dressage?

  2. Valuable advise. I am vertically challanged (5′) and ride an appropriate size horse (14.2) but my stirrups don’t go any shorter. Perhaps a visit to a tack store to investigate if my saddles can be altered is in order.

    • I too am vertically challenged. If you ride English, purchase child’s leathers. If you ride Western, saddle shops should be able to alter your fenders- I took my saddles in and they made it to where my preferred length was right in the middle of the preset adjustments, that way I could adjust up or down if I want to. It was very inexpensive as well- Was around $10-$15 per saddle to have the fenders modified! I didn’t want to risk ruining them by punching holes above the preset holes (I would punch holes in English leathers, but definitely not Western fenders). Hope that helps!

    • I bought youth fenders for my western saddle and also for my Australian saddle.

  3. Thank you ,Julie. This is one of the best explanations on proper stirrup length l have ever read; especially the technique of matching the horse’s shoulder angle and the rider’s thigh angle.

  4. Obviously, you have given a lot of thought to this subject, a subject that is often mostly ignored and should not be. You have included several ideas I have never heard of but make good sense. I just have three comments.

    The faster or more athletically you ride, the shorter your stirrups should be. This encourages the rest of your body to lean forward instead of just bending at the waist.

    In your #2, I had to opposite experience. I remember one ride in particular. I had retired by old quarter horse and years later took him out for what I expected would be a slow ride and thus lengthened my stirrups. Not so. He still had plenty of spunk left and we took off in a rough trot, which I had a tough time sitting. I got off, shortened the stirrups, and was back in rhythm.

    And lastly, most of us have one leg shorter than the other. I feel more in balance having the stirrup just a little shorter on that short side. It may well require getting out a hole punch to add a hole between the pre-punched ones, because we probably are adjusting less than an inch.

    Ted Mann

  5. Very interesting, and I’m especially intrigued by your correlation of stirrup length and shoulder angle. I’ve never noticed that before, but it certainly makes sense. As a lifelong English rider, I was taught both of the first two methods of estimating stirrup length. When mounting a new horse or using a saddle other than my own, I generally use the armpit measurement for a good estimate. I have never heard of the “standing up” method. I can see why that could be faulty. Thanks for the great information!


Leave a Reply to Debi Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.